A-A-50003D
5.3.2 Dimensional. Three pair of drawers, randomly selected from each sample unit, shall be measured for the dimensions specified in Table I. The actual measurements shall be marked on each pair of drawers in preparation for shrinkage testing. Any dimension not meeting the minimum requirement of Table I, on any pair of drawers shall cause rejection of the lot.
5.3.3 Shrinkage. The drawers subjected to dimensional examination shall be used for the shrinkage test. The drawers shall be laundered and dried 5 times in accordance with 3.3.7, and the average measurements (seat width and trunk) of the three pairs of drawers for each size shall be recorded. These measurements shall be compared to the original measurements obtained in
5.3.2. Any difference in average measurements (shrinkage or elongation) of more than 12 percent between the original measurements and the measurements after laundering on any size shall be cause for rejection of the lot.
5.4 Acceptance criteria. Acceptance criteria shall be as specified in the contract or purchase order.
6. PACKAGING. Preservation, packing and marking shall be as specified in the contract or purchase order (see 7.3).
7. NOTES
7.1 Sources of documents.
7.1.1 Copies of government documents are available online at https://assist.daps.dla.mil/quicksearch/ or https://assist.daps.dla.mil/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 1911-5094.
7.1.2 Copies of documents are available online at www.astm.org or from the ASTM INTERNATIONAL, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.
7.1.3 Copies of documents are available online at www.aatcc.org or from the American
Association of Textile Chemists and Colorists, P.O. Box 12215, Research Triangle Park, NC
27709-2215.
7.1.4 Principles and Methods of Toxicology (fourth edition), A Wallace Hayes (editor),pp 1057
- 1060, 2001 are available from Taylor and Francis, Philadelphia PA or https://www.taylorandfrancis.co.uk/.
7.1.5 Federal Acquisition Regulations are available online at https://acquisition.gov/far/index.html or by contacting the Superintendent of Documents at
202-512-1800.
7.2 Standard sample. For access to standard samples, address the contracting activity issuing the invitation for bids or request for proposals. Standard samples are also available at DSCP through https:// warfighter.dla.mil under tab "Vendor Info" then "Specifications/Pattern Request" under "Special Instructions" provide color shade, roll number and solicitation/contract number.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business